User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
119
Return parameter
<string>
Returns the fast sequence
settings in the following
order:
FSeq:ON|OFF;
Memo:<string>, Mode:
CC|CR, Range:
ILVL|IMVL|IHVL|ILVH|
IMVH| IHVH, Loop:
<NR1>|Infinity, Time
Base:<NR2>, Last
Load:ON|OFF,
Last:<NR2>,
RPTSTEP:<NR1>
Example
:FSEQuence HI,CC,ILVL,5,0.3,1,0.7,11
Sets the fast sequence configuration to that shown
below.
Query example
:FSEQuence?
> FSeq:OFF; Memo: HI, Mode:CC, Range:ILVL,
Loop:5, Time Base:300.00, Last Load:OFF,
Last:0.70000, RPTSTEP:11
Returns the fast sequence settings.
:FSEQuence:MEMO
Set
Query
Description
Sets or queries the memo string for the fast
sequence.
Syntax
:FSEQuence:MEMO {<string>}
Query Syntax
:FSEQuence:MEMO?
Parameter
<string>
ASCII character string max
of 12 characters. First
character must be an
alpha character. The string
must be enclosed in
quotes.
Return Parameter
<string>
Memo:<string>
Example
:FSEQuence:MEMO “HI”
Sets the memo string to “HI”.