User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
124
Parameter
Parameters in order:
Description
<NR1>
Current step number
<NR1>
Total number of steps
<NR2>
Value
<bool>|OFF|ON
TRIG OUT setting
Return parameter
<string>
Returns the settings for
the Data Edit for Fast
Sequence menu:
Step:<NR1>/<NR1>,
Value:<NR2>, TRIG
OUT:ON|OFF
Example
:FSEQuence:EDIT 4,11,0.1,OFF
Configures the Data Edit for Normal Sequence menu
to the settings shown below.
Query example
:FSEQuence:EDIT?
> Step:0004/0011; Value:0.10000, TRIG OUT:OFF
:FSEQuence:EDIT:POINt
Set
Query
Description
Sets or queries the current point in the sequence.
Syntax
:FSEQuence:EDIT:POINt {<NR1>}
Query Syntax
:FSEQuence:EDIT:POINt?
Related
Commands
:FSEQuence:EDIT:END?
Parameter/
Return parameter
<NR1>
1~1000*. The current point in the
sequence. *Depends on the number
of steps in the sequence.
Example
:FSEQuence:EDIT:POINt 10
Sets the current point to 10.
Query example
:FSEQuence:EDIT:POINt?
>10
Returns the current point in the sequence.