User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
130
:UTILity:INTerface
Set
Query
Description
Sets or queries the remote interface. Settings only
take effect after restart.
Syntax
:UTILity:INTerface {USB|RS232}
Query Syntax
:UTILity:INTerface?
Parameter/
Return Parameter
USB
USB remote interface
RS232
RS2323 remote interface
Example
:UTILity:INTerface RS232
Sets the interface to RS232.
Query example
:UTILity:INTerface?
>RS232
The current remote interface is RS232.
:UTILity:BRATe
Set
Query
Description
Sets the baud rate when the remote interface is set
to RS232. Settings only take effect after restart.
Syntax
:UTILity:BRATe {<NR1>}
Query Syntax
:UTILity:BRATe?
Parameter/
Return Parameter
<NR1>
2400, 4800, 9600, 19200,
38400
Example
:UTILity:BRATe 9600
Sets the baud rate to 9600.
Query example
:UTILity:BRATe?
>9600
The baud rate is 9600.