User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
148
Syntax
:STATus:CSUMmary:ENABle <NR1>
Query Syntax
:STATus:CSUMmary:ENABle?
Parameter/
Return Parameter
<NR1>
Condition
<NR1>
Condition
1
CC
256
PRUN
2
CR
All other
bits
Not used
4
CV
8
CP
Example
:STATus:CSUMmary:ENABle 1
Enables the CC bit in the CSummary Status Enable
register.
Query example
:STATus:CSUMmary:ENABle?
>1
Indicates that the CC bit is enabled in the CSummary
Status Enable register.
:STATus:CSUMmary[:EVENt]?
Set
Query
Description
Returns the status of the CSummary Status Event
register. The register is cleared upon reading. See
page 153 for details.
Query Syntax
:STATus:CSUMmary[:EVENt]?
Return parameter
<NR1>
Condition
<NR1>
Condition
1
CC
256
PRUN
2
CR
All other
bits
Not used
4
CV
8
CP
Query example
:STATus:CSUMmary:EVENt?
> 1
Indicates that the unit is in CC mode.
:STATus:CSUMmary:NTRansition
Set
Query
Description
Determines whether a negative transition (NTR
10) in the CSummary Status Condition register
will set the corresponding event in the CSummary
Status Event register.