User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
151
Status Registers
To program the PEL-3000 Series effectively, the Status Register
structure needs to be understood. This chapter explains in detail
the structure of the status registers.
Overview
The status registers are used to determine the
status of the electronic load. The status registers
maintain the status of the protection conditions,
load conditions and channel conditions of the
load modules.
The PEL-3000 series have a number of register
groups:
CSummary Registers
Questionable Status Registers
Standard Event Status Registers
Status Byte Register
Service Request Generation Register
Each register group consists of a Condition,
EVENT and ENABLE register. They also have
PTR and NTR (positive and negative transition)
filters.
The structure of the status registers is shown on
the next page.