User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
164
Execution Errors
-200 Execution error
This is the generic syntax error
for devices that cannot detect
more specific errors. This code
indicates only that an Execution
Error as defined in IEEE 488.2 has
occurred.
-201 Invalid while in local
Indicates that a command is not
executable while the device is in
local due to a hard local control
-202 Settings lost due to rtl
Indicates that a setting associated
with a hard local control was lost
when the device changed to
LOCS from REMS or to LWLS
from RWLS.
-203 Command protected
Indicates that a legal password-
protected program command or
query could not be executed
because the command was
disabled.
-210 Trigger error
-211 Trigger ignored
Indicates that a GET, *TRG, or
triggering signal was received
and recognized by the device but
was ignored because of device
timing considerations.
-212 Arm ignored
Indicates that an arming signal
was received and recognized by
the device but was ignored.
-213 Init ignored
Indicates that a request for a
measurement initiation was
ignored as another measurement
was already in progress.