User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
165
-214 Trigger deadlock
Indicates that the trigger source
for the initiation of a
measurement is set to GET and
subsequent measurement query
is received. The measurement
cannot be started until a GET is
received, but the GET would
cause an INTERRUPTED error.
-215 Arm deadlock
Indicates that the arm source for
the initiation of a measurement is
set to GET and subsequent
measurement query is received.
The measurement cannot be
started until a GET is received,
but the GET would cause an
INTERRUPTED error.
-220 Parameter error
Indicates that a program data
element related error occurred.
-221 Settings conflict
Indicates that a legal program
data element was parsed but
could not be executed due to the
current device state.
-222 Data out of range
Indicates that a legal program
data element was parsed but
could not be executed because the
interpreted value was outside the
legal range as defined by the
device.
-223 Too much data
Indicates that a legal program
data element of block, expression,
or string type was received that
contained more data than the
device could handle due to
memory or related device-specific
requirements.