User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
168
-261 Math error in expression
Indicates that a syntactically legal
expression program data element
could not be executed due to a
math error.
-270 Macro error
Indicates that a macro-related
execution error occurred.
-271 Macro syntax error
Indicates that that a syntactically
legal macro program data
sequence, according to IEEE 488.2
could not be executed due to a
syntax error within the macro
definition.
-272 Macro execution error
Indicates that a syntactically legal
macro program data sequence
could not be executed due to
some error in the macro
definition.
-273 Illegal macro label
Indicates that the macro label
defined in the *DMC command
was a legal string syntax, but
could not be accepted by the
device.
-274 Macro parameter error
Indicates that the macro
definition improperly used a
macro parameter placeholder.
-275 Macro definition too long
Indicates that a syntactically legal
macro program data sequence
could not be executed because the
string or block contents were too
long for the device to handle.
-276 Macro recursion error
Indicates that a syntactically legal
macro program data sequence
could not be executed because the
device found it to be recursive.