User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
170
-292 Referenced name does not
exist
-293 Referenced name already exists
-294 Incompatible type
Indicates that the type or
structure of a memory item is
inadequate.
Device Specific Errors
-300 Device-specific error
This is the generic device-
dependent error for devices that
cannot detect more specific
errors.
-310 System error
Indicates that some error, termed
“system error” by the device, has
occurred.
-311 Memory error
Indicates some physical fault in
the device’s memory, such as
parity error.
-312 PUD memory lost
Indicates that the protected user
data saved by the *PUD
command has been lost.
-313 Calibration memory lost
Indicates that nonvolatile
calibration data used by the
*CAL? command has been lost.
-314 Save/recall memory lost
Indicates that the nonvolatile data
saved by the *SAV? command
has been lost.
-315 Configuration memory lost
Indicates that nonvolatile
configuration data saved by the
device has been lost.