User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
2
INTERFACE OVERVIEW
This chapter describes basic configuration of
IEEE488.2 based remote control.
Front Panel Overview ........................................................ 3
Rear Panel Overview .......................................................... 4
Interface Configuration ..................................................... 5
Configure to USB Remote Interface ....................................................................... 5
Configure GPIB Interface ........................................................................................ 6
Configure RS232C ..................................................................................................... 7
RS232C/USB Remote Control Function Check ................................................... 8
Using Realterm to Establish a Remote Connection .............................................. 9
GPIB Function Check ............................................................................................ 13