User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
39
Measurement Commands
:MEASure:CURRent? .......................................................... 39
:MEASure:VOLTage? .......................................................... 39
:MEASure:POWer? .............................................................. 39
:MEASure:ETIMe? ............................................................... 40
:MEASure:CURRent?
Set
Query
Description
This command returns the load current.
Query Syntax
:MEASure:CURRent?
Return parameter
<NR2>
Load current in amps
Query example
:MEASure:CURRent?
>0.79860
Returns the load current in amps.
:MEASure:VOLTage?
Set
Query
Description
This command returns the load voltage.
Query Syntax
:MEASure:VOLTage?
Return parameter
<NR2>
Load voltage in volts
Query example
:MEASure:VOLTage?
>1.49900
Returns the load voltage in volts.
:MEASure:POWer?
Set
Query
Description
This command returns the power.
Query Syntax
:MEASure:POWer?
Return parameter
<NR2>
Power in watts
Query example
:MEASure:POWer?
>1.19695
Returns the power in watts.