User manual

PEL-3000 Programming Manual
70
Current Subsystem Commands
:CURRent[:VA] ..................................................................... 70
:CURRent:VB ........................................................................ 71
:CURRent:SRATe ................................................................. 71
:CURRent:L1 ......................................................................... 72
:CURRent:L2 ......................................................................... 72
:CURRent:SET ...................................................................... 73
:CURRent:LEVel .................................................................. 74
:CURRent:RISE .................................................................... 74
:CURRent:FALL ................................................................... 75
:CURRent:T1 ......................................................................... 75
:CURRent:T2 ......................................................................... 76
:CURRent:FREQuency ........................................................ 77
:CURRent:DUTY ................................................................. 77
:CURRent[:VA]
Set
Query
Description
Sets or queries the CC mode “A Value” (static
mode) current. This command is applicable to
static modes.
Note: A different current value can be set for each
current range (High/Mid/Low).
Note: The [:VA] node can only be omitted when in
static mode.
Syntax
:CURRent[:VA] {<NRf>[ A ] | MINimum | MAXimum }
Query Syntax
:CURRent[:VA]?
Parameter
<NRf>[A]
“A Value” current value
MINIMUM or MIN
Minimum current level
MAXIMUM or MAX
Maximum current level
Return parameter
<NR2>
Returns the “A Value”
current value.
Example
:CURRent:VA MIN
Sets the current value to the minimum.