User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
87
Query Syntax
:RESistance:FREQuency?
Related
Commands
:RESistance:DUTY
Parameter
<NRf>
Sets the switching
frequency in hertz.
MINIMUM or MIN
Minimum frequency
MAXIMUM or MAX
Maximum frequency
Return parameter
<NR2>
Returns the frequency in
hertz.
Example
:RESistance:FREQuency 60
Sets frequency to 60Hz.
Query example
:RESistance:FREQuency?
>60
Returns the switching frequency (60Hz).
:RESistance:DUTY
Set
Query
Description
Sets the positive duty cycle for the CR dynamic
mode switching frequency. This command along
with the “:RESistance:FREQuency” command is
used when the dynamic time setting is set to
“Freq./Duty”.
This command is only applicable for dynamic
mode.
Syntax
:RESistance:DUTY {<NRf> | MINimum | MAXimum}
Query Syntax
:RESistance:DUTY?
Related
Commands
:RESistance:FREQuency
Parameter
<NRf>
Sets the duty as a
percentage.
MINIMUM or MIN
Minimum duty
MAXIMUM or MAX
Maximum duty
Return parameter
<NR2>
Returns the duty as a
percentage.