User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
117
:NSEQuence:EDIT:END?
Set
Query
Description
Returns the number of points in the sequence.
Query Syntax
:NSEQuence:EDIT:END?
Return parameter
<NR1>
1~1000
Query example
:NSEQuence:EDIT:END?
> 20
Indicates that there are 20 steps in the sequence.
:NSEQuence[:DELet]:ALL
Set
Description
Deletes all the data points for the normal sequence.
Syntax
:NSEQuence[:DELet]:ALL
Example
:NSEQuence:ALL
:NSEQuence:SAVE
Set
Description
Saves the data points for the normal sequence.
Syntax
:NSEQuence:SAVE
Example
:NSEQuence:SAVE
:FSEQuence:STATe
Set
Query
Description
Sets or queries the state of the Fast Sequence
function.
Syntax
:FSEQuence:STATe {ON | OFF}
Query Syntax
:FSEQuence:STATe?
Parameter
ON
Turn fast sequence on
OFF
Turn fast sequence off
Return Parameter
ON,STOP
Fast sequence is on
RUN,STOP
Fast sequence is running
OFF
Fast sequence is off