User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
118
Example
:FSEQuence:STATe ON
Turns “Fast Sequence” on.
Query example
:FSEQuence:STATe?
>OFF
“Fast Sequence” is off.
:FSEQuence
Set
Query
Description
Configures the parameters for the Fast Sequence.
This remote command is equivalent to all the
settings in the “Timing Edit for Fast Sequence”
menu when entering the FUNC>Sequence>Fast
Sequence menu.
Syntax
:FSEQuence {<string>,CC|CR,
ILVL|IMVL||IHVL|ILVH|IMVH|IHVH,
<NR1>|INFinity,<NR2>,<bool>|OFF|ON,<NR2>,
<NR1>}
Query Syntax
:FSEQuence?
Related
Commands
:FSEQuence:STATe
Parameter
Parameter in order:
Description
<string>
Memo message. (Need to
enclose in quotes)
CC|CR
Mode
ILVL|IMVL|IHVL|ILVH|
IMVH| IHVH
Range
<NR1>|INFinity
Number of loops
<NR2>
Time base in seconds
<bool> ON|OFF
Last Load 0=Off, 1=On.
Sets the load condition
after the end of the
sequence.
<NR2>
Last value: Sets the value
of the load condition for
Last Load = On
<NR1>
Repeat Step from
(0001~1000) per loop