User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
128
Syntax
:UTILity:LOAD {OFF|ON|LOAD|PROG|NSEQ|FSEQ}
Query Syntax
:UTILity:LOAD?
Parameter
OFF
Turns Auto Load off.
ON
Turns Auto Load on. This
will turn the load on
automatically at start up.
The type of load function
that is automatically
turned on is configured
below.
LOAD
Configure the load to
automatically turn on in
CC, CR, CV or CP mode.
PROG
Configure the load to
automatically turn on a
program sequences.
NSEQ
Configure the load to
automatically turn on a
normal sequence.
FSEQ
Configure the load to
automatically turn on a
fast sequence.
Return Parameter
<string>
Load:On|Off, Load
On:Load|Prog|NSeq|FSeq
Example
:UTILity:LOAD ON FSEQ
Configures the unit to automatically turn fast
sequences on at start up (with the load on).
Query example
:UTILity:LOAD?
> Load:On, Load On:Prog
The unit is configured to automatically turn Programs
on at start up (with the load on).
:UTILity:LOAD:MODE
Set
Query
Description
Sets or queries the Load Off (Mode) setting. This is
equivalent to the settings in the
Shift+UTILITY>Load menu.