User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
133
Example
:UTILity:KNOB OLD
Sets the knob type to OLD.
Query Example
:UTILity:KNOB?
>Old
:UTILity:SPEaker
Set
Query
Description
Turns the speaker on or off.
Note: This will not turn the Go/NoGo alarm tone
settings.
Syntax
:UTILity:SPEaker {<bool>|ON|OFF}
Query Syntax
:UTILity:SPEaker?
Parameter
ON, 1
Speaker on
OFF, 0
Speaker off
Return Parameter
On
Speaker on
Off
Speaker off
Example
:UTILity:SPEaker ON
Turns the speaker on.
Query Example
:UTILity:SPEaker?
>On
:UTILity:ALARm
Set
Query
Description
Enables/disables the alarm tone for the unit.
Syntax
:UTILity:ALARm {<bool>|ON|OFF}
Query Syntax
:UTILity:ALARm?
Parameter
ON, 1
Alarm on
OFF, 0
Alarm off
Return Parameter
On
Alarm on
Off
Alarm off
Example
:UTILity:ALARm ON
Enables the alarm tone.