User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
137
File Commands
:MEMory:SAVE ................................................................. 137
:MEMory:RECall ................................................................ 137
:PRESet:SAVE .................................................................... 138
:PRESet:RECall ................................................................... 138
:SETup:SAVE ..................................................................... 138
:SETup:RECall .................................................................... 138
:FACTory[:RECall] ............................................................. 139
:USER[:DEFault]:SAVE .................................................... 139
:USER[:DEFault]:RECall .................................................. 139
:MEMory:SAVE
Set
Description
Saves Memory Data to internal memory to one of
256 slots.
Syntax
:MEMory:SAVE {<NR1>}
Parameter
<NR1>
M001 ~ M256
Example
:MEMory:SAVE 1
Save Memory Data to M001.
:MEMory:RECall
Set
Description
Recalls Memory Data from internal memory to one
of 256 slots.
Syntax
:MEMory:RECall {<NR1>}
Parameter
<NR1>
M001 ~ M256
Example
:MEMory:RECall 1
Recall Memory Data from M001.