User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
139
Example
:SETup:RECall 1
Recall Setup Data from S001.
:FACTory[:RECall]
Set
Description
Recalls the default settings. See the user manual
for the default settings.
Syntax
:FACTory[:RECall]
Example
:FACTory
:USER[:DEFault]:SAVE
Set
Description
Saves the current settings as the user default.
Syntax
:USER[:DEFault]:SAVE
Example
:USER:SAVE
Saves the current settings as the user default.
:USER[:DEFault]:RECall
Set
Description
Recalls the user default settings.
Syntax
:USER[:DEFault]:RECall
Example
:USER:RECall
Recalls the user default settings.