User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
142
:STATus:QUEStionable:ENABle
Set
Query
Description
Sets which events are enabled in the Questionable
Status Enable register. The mask values are the bit
weights of the events. See page 154 for details.
Syntax
:STATus:QUEStionable:ENABle <NR1>
Query Syntax
:STATus:QUEStionable:ENABle?
Parameter/
Return Parameter
<NR1>
Condition
<NR1>
Condition
1
OV
512
UV
2
OC
1024
EXT
8
OP
2048
REV
16
OT
All other
bits
Not used
Example
:STATus:QUEStionable:ENABle 11
Events OV, OC and OP (Bits 1, 2, 3) are enabled in the
Questionable Status Enable register.
Query example
:STATus:QUEStionable:ENABle?
>11
Indicates that OV, OC and OP bits are enabled in the
Questionable Status Enable register.
:STATus:QUEStionable[:EVENt]?
Set
Query
Description
Returns the status of the Questionable Status Event
register. The register is cleared upon reading. See
page 154 for details.
Query Syntax
:STATus:QUEStionable[:EVENt]?
Return parameter
<NR1>
Condition
<NR1>
Condition
1
OV
512
UV
2
OC
1024
EXT
8
OP
2048
REV
16
OT
All other
bits
Not used