User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
145
Query example
:STATus:OPERation:CONDition?
>32
Indicates that the unit is waiting for a trigger.
:STATus:OPERation:ENABle
Set
Query
Description
Sets which events are enabled in the Operation
Status Enable register. The mask values are the bit
weights of the events. See page 155 for details.
Syntax
:STATus: OPERation:ENABle <NR1>
Query Syntax
:STATus: OPERation:ENABle?
Parameter/
Return Parameter
<NR1>
Condition
<NR1>
Condition
1
CAL
All other
bits
Not used
32
WTG
Example
:STATus:OPERation:ENABle 32
WTG is enabled in the OPERation Status Enable
register.
Query example
:STATus:OPERation:ENABle?
>32
Indicates that the WTG bit is enabled in the Operation
Status Enable register.
:STATus:OPERation[:EVENt]?
Set
Query
Description
Returns the status of the Operation Status Event
register. The register is cleared upon reading. See
page 155 for details.
Query Syntax
:STATus:OPERation[:EVENt]?
Return parameter
<NR1>
Condition
<NR1>
Condition
1
CAL
All other
bits
Not used
32
WTG
Query example
:STATus:OPERation:EVENt?
> 1
Indicates that unit is currently calibrating.