User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
146
:STATus:OPERation:NTRansition
Set
Query
Description
Determines whether a negative transition (NTR
10) in the Operation Status Condition register
will set the corresponding event in the Operation
Status Event register.
The mask values are the bit weights of the
Operation Status NTR filters. See page 155 for
details.
Syntax
:STATus:OPERation:NTRansition <NR1>
Query Syntax
:STATus:OPERation:NTRansition?
Parameter/
Return Parameter
<NR1>
Condition
<NR1>
Condition
1
CAL
All other
bits
Not used
32
WTG
Example
:STATus:OPERation:NTRansition 1
Configures the CAL bit (Bit 1) in the Operation Status
Condition register to set the corresponding bit in the
Questionable Status Enable register on a negative
transition
Query example
:STATus:OPERation:NTRansition?
>1
The CAL bit is configured to NTR in the Operation
Status NTR filter.
:STATus:OPERation:PTRansition
Set
Query
Description
Determines whether a positive transition (PTR
01) in the Operation Status Condition register
will set the corresponding event in the Operation
Status Event register.
The mask values are the bit weights of the
Operation Status PTR filters. See page 155 for
details.