User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
155
PTR/NTR Filters
The PTR/NTR (Positive/Negative transition)
register determines the type of transition
conditions that will trigger an event. Only the
CSummary Status Register, Questionable Status
Register and Operation Status Register can be
transition programmed.
Event Register
The Event Register indicates if an event has
been triggered according to the transition
settings from the PTR/NTR Register.
Enable Register
The Enable register determines which status
event(s) are enabled. Any status events (OV,
OC, OP, OT, UV, EXT or REV) that are enabled
will set the corresponding bit in the
Questionable Event Register.
Operation Status Registers
Overview
The Operation Status Registers will show the
operating state of electronic load (waiting for a
trigger or in calibration mode).
Operation Status Registers
32
5
1-4
1
0
WTG 0 CAL
Bit weight
Bit Position
Condition
WTG 0 CALPTR/NTR
WTG 0 CALEVENT
WTG 0 CALENABLE
Events Bits
CAL: Indicates that the unit is currently in
calibration mode.
WTG: Indicates that the unit is waiting for a
trigger.