User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
162
-131 Invalid suffix
The suffix does not follow the
syntax described in IEEE 488.2 or
the suffix is inappropriate for this
device.
-134 Suffix too long
The suffix contained more than 12
characters.
-138 Suffix not allowed
A suffix was encountered after a
numeric element which does not
allow suffixes.
-140 Character data error
This error is generated when
parsing a character data element.
-141 Invalid character data
Either the character data element
contains an invalid character or
the particular element received is
not valid for the header.
-144 Character data too long
The character data element
contains more than twelve
characters
-148 Character data not allowed
A legal character data element
was encountered where
prohibited by the device.
-150 String data error
This error is generated when
parsing a string data element.
-151 Invalid string data
A string data element was
expected, but was invalid for
some reason.
-158 String data not allowed
A string data element was
encountered but was not allowed
by the device at this point in
parsing.
-160 Block data error
This error is generated when
parsing a block data element.
-161 Invalid block data
A block data element was
expected, but was invalid for
some reason.