User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
169
-277 Macro redefinition not allowed
Indicates that a syntactically legal
macro label in the *DMC
command could not be executed
because the macro label was
already defined.
-278 Macro header not found
Indicates that a syntactically legal
macro label in the *GMC? query
could not be executed because the
header was not previously
defined.
-280 Program error
Indicates that a downloaded
program-related execution error
occurred.
-281 Cannot create program
Indicates that an attempt to create
a program was unsuccessful. A
reason for the failure might
include not enough memory.
-282 Illegal program name
The name used to reference a
program was invalid.
-283 Illegal variable name
An attempt was made to
reference a nonexistent variable
in a program.
-284 Program currently running
Certain operations dealing with
programs may be illegal while the
program is running.
-285 Program syntax error
Indicates that a syntax error
appears in a downloaded
program.
-286 Program runtime error
-290 Memory use error
Indicates that a user request has
directly or indirectly caused an
error related to memory or
<data_handle>s, this is not the
same as “bad” memory.
-291 Out of memory