User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
171
-320 Storage fault
[Indicates that the firmware
detected a fault when using data
storage. This error is not an
indication of physical damage or
failure of any mass storage
element.
-321 Out of memory
An internal operation needed
more memory than was available.
-330 Self-test failed
-340 Calibration failed
-350 Queue overflow
A specific code entered into the
queue in lieu of the code that
caused the error. This code
indicates that there is no room in
the queue and an error occurred
but was not recorded.
-360 Communication error
This is the generic
communication error.
-361 Parity error in program
message
Parity bit not correct when data
received.
-362 Framing error in program
message
A stop bit was not detected when
data was received.
-363 Input buffer overrun
Software or hardware input
buffer on serial port overflows
with data caused by improper or
nonexistent pacing.
-365 Time out error
This is a generic device-
dependent error.
Query Errors
-400 Query error
This is the generic query error.
-410 Query INTERRUPTED
Indicates that a condition causing
an INTERRUPTED Query error
occurred.