User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
24
Commands
:POWer:VB ........................................................................... 92
:POWer:L1 ............................................................................. 92
:POWer:L2 ............................................................................. 93
:POWer:SET ......................................................................... 93
:POWer:LEVel ...................................................................... 94
:POWer:T1 ............................................................................ 95
:POWer:T2 ............................................................................ 95
:POWer:FREQuency ........................................................... 96
:POWer:DUTY ..................................................................... 97
Function
Commands
:PROGram:STATe ............................................................... 99
:PROGram ........................................................................... 100
:PROGram[:RECall]:DEFault .......................................... 101
:PROGram:STARt ............................................................. 101
:PROGram:STEP ............................................................... 102
:PROGram:MEMory ......................................................... 102
:PROGram:RUN ................................................................ 102
:PROGram:ONTime ......................................................... 103
:PROGram:OFFTime ........................................................ 103
:PROGram:PFTime ........................................................... 104
:PROGram:STIMe ............................................................. 104
[:PROGram]:CHAin:STARt ............................................. 105
[:PROGram]:CHAin .......................................................... 105
[:PROGram]:CHAin:P2P .................................................. 107
[:PROGram]:CHAin[:RECall]:DEFault .......................... 107
:PROGram:SAVE .............................................................. 108
:NSEQuence:STATe .......................................................... 108
:NSEQuence........................................................................ 109
:NSEQuence:STARt .......................................................... 110
:NSEQuence:NUMBer ...................................................... 111
:NSEQuence:MEMO ......................................................... 111
:NSEQuence:MODE ......................................................... 112
:NSEQuence:RANGe ........................................................ 112
:NSEQuence:LOOP .......................................................... 113
:NSEQuence:LLOad .......................................................... 113
:NSEQuence:LAST ............................................................ 114
:NSEQuence:CHAin .......................................................... 114
:NSEQuence:EDIT ............................................................ 115
:NSEQuence:EDIT:POINt .............................................. 116
:NSEQuence:EDIT:END? ............................................... 117
:NSEQuence[:DELet]:ALL ............................................... 117
:NSEQuence:SAVE ........................................................... 117
:FSEQuence:STATe ........................................................... 117