User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
25
:FSEQuence......................................................................... 118
:FSEQuence:MEMO .......................................................... 119
:FSEQuence:MODE .......................................................... 120
:FSEQuence:RANGe ......................................................... 120
:FSEQuence:LOOP ........................................................... 121
:FSEQuence:TBASe ........................................................... 121
:FSEQuence:LLOad ........................................................... 122
:FSEQuence:LAST ............................................................. 122
:FSEQuence:RPTStep ........................................................ 123
:FSEQuence:EDIT ............................................................. 123
:FSEQuence:EDIT:POINt ............................................... 124
:FSEQuence:EDIT:END? ................................................ 125
:FSEQuence[:DELet]:ALL ................................................ 125
:FSEQuence[:EDIT]:FILL ................................................ 125
:FSEQuence:SAVE ............................................................ 126
Utility
Commands
:UTILity:SYSTem? ............................................................. 127
:UTILity:LOAD .................................................................. 127
:UTILity:LOAD:MODE ................................................... 128
:UTILity:LOAD:RANGe .................................................. 129
:UTILity:INTerface ............................................................ 130
:UTILity:BRATe ................................................................. 130
:UTILity:SBIT ..................................................................... 131
:UTILity:PARity .................................................................. 131
:UTILity:TIME ................................................................... 132
:UTILity:KNOB ................................................................. 132
:UTILity:SPEaker ............................................................... 133
:UTILity:ALARm ............................................................... 133
:UTILity:UNReg ................................................................. 134
:UTILity:GNG .................................................................... 134
:UTILity:CONTrast............................................................ 135
:UTILity:BRIGhtness ......................................................... 135
:UTILity:LANGuage .......................................................... 135
File Commands
:MEMory:SAVE ................................................................. 137
:MEMory:RECall ................................................................ 137
:PRESet:SAVE .................................................................... 138
:PRESet:RECall ................................................................... 138
:SETup:SAVE ..................................................................... 138
:SETup:RECall .................................................................... 138
:FACTory[:RECall] ............................................................. 139
:USER[:DEFault]:SAVE .................................................... 139