User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
26
:USER[:DEFault]:RECall .................................................. 139
SCPI Register
Commands
:SYSTem:ERRor? ............................................................... 140
:STATus:PRESet ................................................................ 141
:STATus:QUEStionable:CONDition? ............................ 141
:STATus:QUEStionable:ENABle .................................... 142
:STATus:QUEStionable[:EVENt]? .................................. 142
:STATus:QUEStionable:NTRansition ............................. 143
:STATus:QUEStionable:PTRansition.............................. 144
:STATus:OPERation:CONDition? .................................. 144
:STATus:OPERation:ENABle ......................................... 145
:STATus:OPERation[:EVENt]? ....................................... 145
:STATus:OPERation:NTRansition .................................. 146
:STATus:OPERation:PTRansition ................................... 146
:STATus:CSUMmary:CONDition? .................................. 147
:STATus:CSUMmary:ENABle ......................................... 147
:STATus:CSUMmary[:EVENt]? ....................................... 148
:STATus:CSUMmary:NTRansition .................................. 148
:STATus:CSUMmary:PTRansition ................................... 149