User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
31
Query example
*SRE?
>12
Bits 2 and 3 are set in the Service Request Enable
register.
*STB?
Set
Query
Description
Reads the Status Byte register. This command will
not clear the Status Byte register.
If the Master Summary Status bit (MSS) is set, it
indicates that there is a reason for a service
request.
Query Syntax
*STB?
Return parameter
<NR1> (bit weight)
Bit number / Description
1
0/Not used
2
1/ERR
4
2/ CSUM
8
3/ QUES
16
4/ MAV
32
5/ ESB
64
6/ RQS_MSS
128
7/ OPER
Note: Bit 1 and 2 cannot be set, however bit 2 (ERR)
can be returned.
Query example
*STB?
>36
Bits 2 and 5 are set in the Status Byte register.
*TRG
Set
Description
This command triggers the unit.
Syntax
*TRG