User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
35
Return parameter
0
Continuous = OFF
1
Continuous = ON
Example
:INITiate:CONTinuous ON
Configures the trigger to go to the wait state after a
trigger.
Query example
:INITiate:CONTinuous?
>1
Indicates that the trigger will to go to the wait state
after a trigger.
:CURRent[:VA]:TRIGgered
Set
Description
Sets the current generated when the trigger is
activated.
Syntax
:CURRent[:VA]:TRIGgered {<NR2>[ A ] |MINimum |
MAXimum }
Parameter
<NR2>[ A ]
Current in amps.
MINIMUM or MIN
MINIMUM value.
MAXIMUM or MAX
MAXIMUM value.
Example
:CURRent:TRIGgered MAX
Sets the current generated to the maximum value.
:RESistance[:VA]:TRIGgered
Set
Description
Sets the conductance for when the trigger is
activated.
Syntax
:RESistance[:VA]:TRIGgered {<NR2>[ mho ]
|MINimum | MAXimum }
Parameter
<NR2>[ mho ]
Conductance in mho.
MINIMUM or MIN
MINIMUM value.
MAXIMUM or MAX
MAXIMUM value.