User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
41
Configure Subsystem Commands
[:CONFigure]:OCP .............................................................. 41
[:CONFigure]:OPP ............................................................... 42
[:CONFigure]:UVP............................................................... 43
[:CONFigure]:OVP .............................................................. 43
[:CONFigure]:SSTart ............................................................ 44
[:CONFigure]:VON ............................................................. 45
[:CONFigure]:VDELay ........................................................ 45
:CONFigure:RESPonse ....................................................... 46
[:CONFigure]:CNTime ........................................................ 46
[:CONFigure]:COTime ........................................................ 47
[:CONFigure]:CRUNit ......................................................... 48
:CONFigure:DYNamic ........................................................ 48
:CONFigure:MEMory .......................................................... 49
:CONFigure:SHORt............................................................. 49
[:CONFigure]:GNG:SPECtest ........................................... 50
[:CONFigure]:GNG:DTIMe .............................................. 50
[:CONFigure]:GNG:MODE .............................................. 51
[:CONFigure]:GNG[:PASS] ................................................ 51
[:CONFigure]:GNG:H ........................................................ 52
[:CONFigure]:GNG:L ......................................................... 52
[:CONFigure]:GNG:C ......................................................... 53
[:CONFigure]:OCP
Set
Query
Description
Sets or queries the OCP trip settings. The OCP
limit can be set to a specific value or the trip setting
can be set to either limit the current or to turn the
load off.
Syntax
[:CONFigure]:OCP {<NRf>[ A ] | MINimum |
MAXimum | LIMit | LOFF }
Query Syntax
[:CONFigure]:OCP?
Parameter
<NRf>[A]
Current limit value.