User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
48
[:CONFigure]:CRUNit
Set
Query
Description
Sets or queries the CR mode setting units.
Syntax
[:CONFigure]:CRUNit {OHM|MHO}
Query Syntax
[:CONFigure]:CRUNit?
Parameter/
Return parameter
OHM
Set the units to ohms.
MHO
Set the units to mho
(conductance)
Example
:CRUNit OHM
Sets the CR mode units to ohms.
Query example
:CRUNit?
>OHM
The CR mode units are ohms.
:CONFigure:DYNamic
Set
Query
Description
Sets the display units for when dynamic mode
switching is used. Units can be selected from
Percent and Value. See the user manual for further
details. This command will also configure whether
to switch between each level using timers or a set
duty cycle.
Syntax
:CONFigure:DYNamic { VALue | PERCent | TIME |
FDUTy }
Query Syntax
:CONFigure:DYNamic?
Parameter
VALUE or VAL
Set the units to Value.
PERCENT or PERC
Set the units to Percent.
TIME
Use timers for timing.
FDUTY or FUDT
Use duty cycle for timing.
Return parameter
<ASCII string>
Return a string containing
the unit mode and the
timing mode.
Example
:CONFigure:DYNamic VALue
Sets the dynamic mode units to value.