User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
67
Mode Subsystem Commands
:MODE .................................................................................. 67
[:MODE]:CRANge............................................................... 67
[:MODE]:VRANge .............................................................. 68
[:MODE]:RESPonse ............................................................ 68
[:MODE]:DYNamic............................................................. 69
:MODE
Set
Query
Description
Sets the operating mode.
Syntax
:MODE {CC | CR | CV | CP | CCCV | CRCV | CPCV }
Query Syntax
:MODE?
Parameter/Return
parameter
CC
CC mode
CR
CR mode
CV
CV mode
CP
CP mode
CCCV
CC + CV mode
CRCV
CR + CV mode
CPCV
CP + CV mode
Example
:MODE CC
Sets the mode to CC mode.
Query example
:MODE?
>CC
Returns the operating mode (CC mode).
[:MODE]:CRANge
Set
Query
Description
Configures the current range for all the applicable
operating modes.
Syntax
[:MODE]:CRANge {HIGH | MIDDle | LOW }
Query Syntax
[:MODE]:CRANge?