User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
PEL-3000 Programming Manual
84
Example
:RESistance:LEVel MIN
Sets the % level conductance value to the minimum.
Query example
:RESistance:LEVel?
>50
Returns the “% Level” as 50 percent.
:RESistance:RISE
Set
Query
Description
Sets the rising current slew rate for CR dynamic
mode.
Syntax
:RESistance:RISE {<NRf> | MINimum | MAXimum }
Query Syntax
:RESistance:RISE?
Related
Commands
:RESistance:FALL
Parameter
<NRf>
Rising current slew rate
[mA/us]
MINIMUM or MIN
Minimum slew rate
MAXIMUM or MAX
Maximum slew rate
Return parameter
<NR2>
Returns the rising current
slew rate in mA/us.
Example
:RESistance:RISE MIN
Sets the rising slew rate to the minimum.
Query example
:RESistance:RISE?
>50.000
Returns the rising slew rate as 50mA/us.
:RESistance:FALL
Set
Query
Description
Sets the falling current slew rate for CR dynamic
mode.
Syntax
:RESistance:FALL {<NRf> | MINimum | MAXimum }
Query Syntax
:RESistance:FALL?