User manual

PSU Programming Manual
76
Source Commands
[:SOURce]:CURRent:EXTernal:RANGe ........................... 76
[:SOURce]:CURRent:EXTernal:SOURce .......................... 77
[:SOURce]:CURRent[:LEVel][:IMMediate]
[:AMPLitude] .......................................................................... 77
[:SOURce]:CURRent[:LEVel]:TRIGgered[:AMPLitude] . 78
[:SOURce]:CURRent:LIMit:AUTO .................................... 78
[:SOURce]:CURRent:PROTection:DELay ........................ 78
[:SOURce]:CURRent:PROTection[:LEVel] ...................... 79
[:SOURce]:CURRent:PROTection:STATe ........................ 79
[:SOURce]:CURRent:PROTection:TRIPped .................... 80
[:SOURce]:CURRent:SLEW:RISing ................................... 80
[:SOURce]:CURRent:SLEW:FALLing ............................... 81
[:SOURce]:MODE? .............................................................. 81
[:SOURce]:RESistance[:LEVel][:IMMediate]
[:AMPLitude] .......................................................................... 81
[:SOURce]:VOLTage[0]:EXTernal:RANGe ...................... 82
[:SOURce]:VOLTage[0]:EXTernal:SOURce ..................... 82
[:SOURce]:VOLTage[0][:LEVel][:IMMediate]
[:AMPLitude] .......................................................................... 83
[:SOURce]:VOLTage[0][:LEVel]:TRIGgered
[:AMPLitude] .......................................................................... 83
[:SOURce]:VOLTage[0]:LIMit:AUTO ............................... 84
[:SOURce]:VOLTage[0]:LIMit:LOW ................................. 84
[:SOURce]:VOLTage[0]:PROTection[:LEVel] ................. 85
[:SOURce]:VOLTage[0]:PROTection:TRIPped ............... 85
[:SOURce]:VOLTage[0]:SLEW:RISing .............................. 86
[:SOURce]:VOLTage[0]:SLEW:FALLing .......................... 86
[:SOURce]:CURRent:EXTernal:RANGe
Set
Query
Description
Sets or queries the CC or CV control range that is
used during external control. Note: the setting will
only be valid after the power has been cycled.
Syntax
[:SOURce]:CURRent:EXTernal:RANGe {LOW|HIGH}
Query Syntax
[:SOURce]:CURRent:EXTernal:RANGe?
Parameter/Return
parameter
LOW
A range of 0 V to 5 V is used.
HIGH
A range of 0 V to 10 V is used.