User Manual
SFG-1000 Series User Manual
34
FAQ
●
I pressed the Power switch on the front panel but nothing happens.
●
How can I get out of TTL/−40dB mode?
●
The device accuracy does not match the specification.
●
What are these error messages?
I pressed the Power switch on the front panel but nothing happens.
Make sure the AC source voltage is set at the rating
±10%, 50/60Hz. For power up sequence, see page17.
Otherwise the internal fuse might be blown out. For fuse
replacement procedure, see page35.
TTL does not activate (pressed Shift + Wave key)
You need to turn On the output first. Press the Output
key, then press Shift+Wave. For details, see page25.
How can I get out of TTL/−40dB mode?
For TTL: press the Shift key, then the wave key. For
details, see page25.
For −40dB mode, press the Shift key, then 3. For details,
see page22.
The device accuracy does not match the specification.
Make sure the device is powered On for at least 30
minutes, within +18°C~+28°C. This is necessary to
stabilize the unit to match the specification.
What are these error messages?
Several messages appear when trying to set the frequency
in irregular ways. Page37 summarizes the messages.
If there is still a problem, please contact your local dealer or GWInstek at
www.gwinstek.com.tw / marketing@goodwill.com.tw.