Instruction Manual

`
Cylinders must be stored outdoors in an upright position and out of the reach of children. The cylinder must
never be stored where temperatures can reach over 50C. Do not store the cylinder near flames, pilot lights
or other sources of ignition. DO NOT SMOKE.
This barbecue is designed for use outdoors, away from any flammable materials. It
is important that there are no overhead obstructions and that there is a minimum
distance of 122cm from the side or rear of the appliance. It is important that the
ventilation openings of the appliance are not obstructed. The barbecue must be
used on a level, stable surface. The appliance should be protected from direct draughts and shall be
positioned or protected against direct penetration by any trickling water (e.g. rain).
Make sure that the gas cylinder compartment (if any) is not obstructed, keep it ventilated and clean.
Parts sealed by the manufacturer or his agent must not be altered by the user. No modifications
should be made to any part of this barbecue and repairs and maintenance should only be carried out
by a CORGI registered service engineer.
Connection to Appliance
Before connection, ensure that there is no debris caught in the head of the gas cylinder, regulator, burner
and burner ports. Spiders and insects can nest within and clog the burner/venturi tube at the orifice. A
clogged burner can lead to a fire beneath the appliance.
Clean burner holes with a heavy-duty pipe cleaner.
Fit the hose to the appliance using a spanner to tighten it onto the connection thread. If the hose is replaced
it must be secured to the appliance and regulator connections with hose clips. Disconnect the regulator from
the cylinder (according to the directions supplied with the regulator) when the barbecue is not in use.
The Barbecue must be used in a well ventilated area. Do not obstruct the flow of combustion air to the
burner when the barbecue is in use. ONLY USE THIS BARBECUE OUTDOORS.
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts water.
Ensure the control valve is “OFF”.
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure
then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be
rectified before use.
Retest after fixing the fault
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified. Do not attempt to cure leakage but consult your gas dealer.
Lighting Instructions for beefer grill
1. Read and follow the operator’s instructions in owner’s manual before lighting.