Instruction Manual

`
2. Make sure the control knobs are in OFF position,open gas bottle valve according to instructions.
3. Push the knob ,and turn anti-clockwise to the “MIN” position,this will light the burner.
If not repeat this process.
4. Adjust the heat by turning the knob to the MAX/MIN position.
5. To turn the beefer grill OFF . Turn the cylinder valve or regulator switch to the “OFF” position and then
Turn the control knob on the appliance clockwise to the OFF position.
Put 1.5V battery inside before light.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off.
Wait five minutes before attempting to relight with ignition sequence.
Clean your barbecue after each USE. DO NOT use abrasive or flammable cleaners, as it will damage the
parts of the product and may start a fire. Clean in warm soapy water.
WARNING: Accessible parts may be very hot. Keep young children away from the hot appliance at all times
(even while cooling down!).
It is recommended that protective gloves (eg oven gloves) be used when handling particularly hot
components.
CLEANING AND CARE
CAUTION: All cleaning and maintenance should be carried out when the barbecue is cool and with the
fuel supply turned OFF at the gas cylinder.
CLEANING
“Burning off” the barbecue after every use (for approx 15 minutes) will keep excessive food residue to a
minimum.
OUTSIDE SURFACE
Use mild detergent or baking soda and hot water solution. Non-abrasive scouring powder can be used on
stubborn stains, then rinse with water.
If the inside surface of the barbecue lid has the appearance of pealing paint, baked on grease build-up has
turned to carbon and is flaking off. Clean thoroughly with strong hot soapy water solution. Rinse with water
and allow to completely dry. NEVER USE OVEN CLEANER.
INTERIOR OF BARBECUE BOTTOM
Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water solution. Rinse with
water and allow to dry.
COOKING GRID
Use a mild soapy water solution. Non-abrasive scouring power can be used on stubborn stains then rinse
with water.
Turn the gas OFF at the control knob and disconnect the cylinder.
Remove cooling grate.