Electric Water Heater User's Manual

ManualsBrandsHaier ManualsWater HeaterLittle Sea-ox FCD JTHA40-III(E), FCD-JTHA50-III(E), FCD-JTHA60-III(E)

Haier Garden, Qianwangang Road, Economic Development Zone,Qingdao, P. R. China

Group

Qingdao Economic and Technological Development District

Haier Water Heater Co., Ltd.

Please read this manual before usage

Retain it for future reference

Little Sea-ox

Haier Household Electric Water Heater

User' Manual

FCD JTHA40- E

FCD JTHA50- E

FCD JTHA60- E

Summary of content (6 pages)

PAGE 1
Little Sea-ox Haier Household Electric Water Heater FCD JTHA40- E FCD JTHA50- E FCD JTHA60- E Group Qingdao Economic and Technological Development District Haier Water Heater Co., Ltd. Haier Garden, Qianwangang Road, Economic Development Zone,Qingdao, P. R.
PAGE 2
Pre-safe Expert This mark is the designation for Pre-Safe Expert of Haier Water Heater Company, which indicates use of the company's patented technology inside the product. It ensures you a safe bath while monitoring whether your house ground wire is live or not all the time. If this mark is lighted on, it indicates your house ground wire has come live (poor grounding and live).
PAGE 3
Cleaning and Maintenance Before Usage Statement: This water heater shall only be repaired and maintained by qualified servicemen. Improper maintenance may cause severe injury or damage. Before opening or repairing water heater, please do pull out the power plug. Dear users, Note: the product, please read the manual and operate accordingly. Please retain it for future Before asking for service, please refer to troubleshooting section to resolve easy problems.
PAGE 4
Operation Instructions Parameters Rated voltage: 220V~,50Hz Power: 1500W Rated pressure: 0.65 / 0.75MPa Waterproof grade: IPX 4 ( ) Dimension: (See to Figure 1) Weight: (See to Figure 1) Volume: (See to Figure 1) Tap water pressure: no less than 0.05MPa For the first use after installation, due to there's no water within the tank, first the city water inlet valve and mixing valve must be opened.
PAGE 5
Safety Precautions Installation The water may drip from the discharge pipe of the 50 Hz 22 0V pressure relied device and that this pipe must be installed in a continuously downward direction and in a frost-free environment. Check safety valve once a month as follow: move the small handle of safety valve, if there's water flowing out, safety valve is normal; if there's no water flow, please contact local after-sales service station.
PAGE 6
Setting Environment Installation Installation must be made by installers of or designated by our company after-service department. The water heatershall be wall-mounted. Before installation, make sure water heater rear wires are fit firmly. Determine an installation location. Make four holes 12mm, 65 mm deep in the wall with an impact drill according to installating dimension. Insert fixexpansion hooks and expansion bolts in corresponding wall holes. Lift the water heater.