LED LCD TV RECEIVER USER MANUAL Please read this manual carefully before using your television and keep this manual in a good place for future reference.
01 Safety and warnings Welcome ………………………………………………………………………… P.02 Important information ……………………………………………………………P.02 Safety notice …………………………………………………………………… P.03 Warnings and cautions ………………………………………………………… P.05 02 Introduction Main Parameter ………………………………………………………………… P.06 Base Stand Assembly Instruction …………………………………………… P.08 Wall Mounting Installation Guidelines ……………………………………… P.09 Control Panel …………………………………………………………………… P.10 Rear/Side Sockets ……………………………………………………………… P.
Thanks for buying this 26"/32" LED LCD TV with DVD Player. This guide will help you set up and begin using your TV.
the accessable. P.
UK Only 13A Plug Connection. If your TV is connected to the mains supply using a 3 pin 13 amp plug, the voltage rating is 220240 volts and should be protected by a 3 amp fuse in the plug. Should the fuse require replacement for any reason, the fuse must be replaced with a fuse rated at 3 amps and manufactured and approved to Bs1362.
WARNINGS AND CAUTIONS Caution Do not trap the power supply cord under the television receiver. Warning To prevent fire or electrical shock hazard, do not expose the television receiver to rain or moisture. Caution Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Serious injury may result if it should fall. Warning Caution Do not place your television on an unstable cart, stand, shelf or table.
02 Introduction INSTALLATION CAUTION Never tamper with any components inside the TV, or any other adjustment controls not mentioned in this manual. All LED-TVs are high voltage instruments. When you clean up dust or water drops on the LED PANEL or CABINET, the power cord should be pulled out from the receptacle, then wipe the TV with a dry soft cloth. During thunder and lighting, unplug the power cord and antenna cord to prevent damage to your TV.
PC PRESET MODE P.07 V.Freq.(Hz) H.Freq.(KHz) 1 640x480 60 31.47 2 800x600 60 37.88 3 1024x768 60 48.36 4 1360x768 60 47.7 5 1280x1024 60 63.98 6 1920x1080 60 66.
Base Stand Assembly Instruction 1. Insert the stand support pillar into the stand as the arrow indicated direction, and then fastened with three screws. 2. Insert the stand Ass'y into back cover as the arrow indicated direction, and then fastened with one screw. INSTALLATION NOTES Locate the TV in a room where light does not strike the screen directly. Total darkness or a reflection on the screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing.
WALL MOUNTING INSTALLATION GUIDELINES This television can be wall mounted as follows: 1.Place the LED LCD Television onto a solid surface. Please place some soft material over the front of the screen to protect it from any damage. 2.Remove the screws from the lower part of the television, where the base joins to the TV, and take away the stand (put the stand somewhere safe for future use). 3.
Front control panel SOURCE 1 MENU 2 CH+ 3 3 CHVOL+ 4 VOL- 1 STANDBY 5 2 1 2 3 Remote control sensor. Indicator LED: BLUE: POWER ON. RED: STAND BY. Key board. 1 2 3 SOURCE MENU CH+/CH- 4 VOL+/VOL- 5 STANDBY Display the input source menu. Display main MENU. In TV mode,press CH+ or CH- to change the channel up and down. In MENU, press CH+ or CH- to select items . In standby mode, it can Turn on the TV. Adjust sound level. In MENU,adjust the item that you Selected.
Connecting to your Haier TV Connecting a DVD player / Satellite / cable set top box receiver / games console / PC or Laptop There are several options to connecting a DVD player / Satellite or Cable set top box receiver / games console / PC or Laptop to your TV. SCART Option 5 Connect a SCART cable (not supplied) from the SCART socket on the TV to the DVD player / Satellite or cable set top box receiver or games consol.
COMMON INTERFACE The common interface (CI) slot is designed to accept the conditional Access (CA) Module and Smart card in order to view the pay TV programmes and additional services. Contact your Common Interface service provider to get more information about the modules and subscription. Please noted that CA modules and smart cards are neither supplied nor optional accessories from us.
POWER MUTE TV AUDIO 1 2 3 RECALL/GOTO 4 5 6 7 8 9 0 TV MENU SOURCE OK DVD MENU SOUND EXIT PIC CH + + VOL _ _ SLEEP DVD SETUP ASPECT TV/RADIO FAV EPG A-B TITLE RETURN DISPLAY REVEAL HOLD SUBPAGE SIZE TEXT INFO PBC ANGLE DVD AUDIO SUBTITLE LIST INDEX MIX FREEZE 1: POWER:Press to turn the un it on or off . 2: NUMERIC KEY:Press for di rect acc ess to cha nn el s. 3: TV MENU:Press to di spl ay TV Mai n Men u. 4: CURSOR:Press to scrol l throug h the Men u.
REMOTE CONTROL TELETEXT Press: TEXT E Teletext is an information system broadcast by certain channels which can be consulted like a newspaper. It also offers access to subtitles for viewers with hearing problems or who are not familiar with the transmission language(cable networks, satellite channels, etc.) You will obtain: This is used to call or exit teletext modes. The summary appears with a list of items that can be accessed. Each item has a corresponding 3 digit page number.
04 OPERATION Installation Guide Tune Type Please select an OSD Language Cesky Engli sh Fran ais Magyar Dansk Espanol Hrvatski Nederla nds Portugues Deutsch E Itali ano ~ ka Norsk Pols ki DTV+ATV Norway Germany Italy Greece Luxembourg Pola nd Hungary Netherla nds Portugal MENU Pycck Please press to select country at first , then press OK button to start auto tuning .
ATV Manual Tunin g _ Storage To 1 + System BG 5). CI information: (optional) This menu can display the CI card' s information. Current CH 1 2. PICTURE MENU Search Fin e-Tune Frequency 255.25 MHz Save Once your favorite group is created, you can press the FAV key to quickly access your favorite channel. The second item of the MENU is PICTURE MENU. You can adjust picture effect here, such as contrast, brightness, etc. Press OK to move, press OK to adjust.
TIME -- > NOTE: Within 15 minutes there is no signal, the TV will auto sleep , if Auto Sleep is set ON. The clock time can get from the DTV system auto. 5.
8.PVR function 1.Prepare to record the program From OPTION MENU enter into PVR File System In “OPTION MENU”, please choose “check PVR File System”. Click “OK”, until “checking”change into “Success”. Note: please check the term “speed”. If it is “HD support”, that means the speed of USB device is available for time shift and record. If not, please format the device, to make sure the device available. The default “Free Record Limit” is 6 hour, if the space on the disk is big enough.
(Suggest to format the format the device by “High Speed Fs...”, which can speed up the record.) Format dis k Format dis k 2.Record the program As playing the DTV source, choose the channel and click “record”, the record frame will pop up. Click “record” again, the record frame will disappear and the “REC” icon still on the left top. It will disappear until you click “stop”. Warnin g! All data will be lo st. 3.
9.Timeshift function 1.Prepare to record the program This TV allows you to pause and record the currently watched digital program to a USB storage device, and to resume to the point where it was paused. 00:00:33/00:04:22 Play FB FF Prev . Ne xt Pause Stop NOTE: Formatting a USB 2.0 storage device will be needed. Save your original data before formatting. All the data stored in the USB device will be erased after formatting.
Time Shift limitations: 1. When the Time Shift feature is activated, only the PLAY/PAUSE/STOP/FWD/REV/ VOL+/VOL-/MUTE keys and some basic operation keys (ENTER/EXIT/navigation keys) are available. 2. Video playback may not be smooth and skip if USB recording speed does not meet the minimum requirements . 3. Do Not remove USB disk or switch off the power during Time Shift operations. It will abort once the signal is lost. 4. Do Not remove the signal source during Time Shift operations. 5.
10.USB Player 00:00:33/00:04:22 Press source key, and selsct USB in soure list, press OK button to enter the USB menu. FB FF Prev . Ne xt Stop Repeat ALL Inf o. Press to select the function icon, press OK button to confirm the function. Press or EXIT button to exit the control bar. NOTE: You can adjust the audio track, or program in the Info menu while Playing the video file.Choose the Info icon and press OK can display the Info MENU. USB 2.0 PHOTO Pause MUSIC MOVIE TEXT Sample1.
05 DVD OPERATION DVD SIDE PANEL 9 MPEG4 files on discs Multi-angle 32 OPEN/CLOSE Dolby Digital Subtitle choices PLAY/PAUSE 8 KODAK picture CD Audio choices Caution 16:9 MP3 files on CD-R/CD-RW LB TV Aspect Ratio modes R RESTRICTED Features Disc formats supported by this player: DVD video Parental Lock This product incorporates copyright protection technology that is protected by method claims of certain U.S.
Remote Control - DVD section POWER MUTE TV AUDIO 1 2 3 RECALL/GOTO 4 5 6 7 8 9 0 TV MENU SOURCE OK DVD MENU SOUND EXIT PIC CH + + VOL _ _ SLEEP DVD SETUP ASPECT TV/RADIO FAV EPG TEXT INFO PBC ANGLE A-B TITLE RETURN DISPLAY REVEAL HOLD LIST INDEX SUBPAGE SIZE MIX FREEZE DVD AUDIO SUBTITLE 2:Numeric keys:Press to set the time, select title, chapter or track you wish to play. Press the ENTER/OK Button to confirm.
DVD OPERATION MENU OPERATION Press the SETUP button on the remote control, the SETUP MENU will be displayed. After accessing the setup menu, press the direction buttons for up and down movement to select an item desired, and press RIGHT direction button to select the lower item. Then press the OK button to confirm. Press LEFT direction button return to the menu of upper level. To exit the setup, press the SETUP button again. In the SETUP MENU, you may choose any of the following options as you like.
DVD OPERATION MP3/WMA/JPEG/MPEG4 PLAYBACK Press Direction key to choose the root directory and then press OK button to enter into the sub directory. Press Direction key to choose the desired picture and then press OK or PLAY to enjoy the picture. If you want to return to the upper menu, press Direction key to choose the icon and press OK button. Image rotation In picture play state, press Direction key to rotate the picture. The MP3/WMA/MPEG4 disc has such a directory structure as shown picture above .
06 DVD Trouble shooting If you have any questions, please consult the troubleshooting guide below: NO PICTURE OR SOUND Ensure the power button is on. Ensure the power outlet is operational. Ensure the power cord is not damaged. Ensure the power plug is connected firmly to the outlet. REMOTE NOT WORKING Make sure the Main unit s POWER button is on Ensure the remote batteries are working. Point the remote control directly at the player s IRsensor. Remove any obstacles between the remote and theIR sensor.
07 Trouble shooting Trouble phenomenon Symptom Inspection Check Audio Snow Noise antenna position, direction or connection Ghost Normal audio antenna position, direction or connection Interference Noise electronic equipment,car/ motorcycle,fluorescent light Mute Volume(check if mute is activated or if the audio system connections are not correct) Normal Picture Power cord is not inserted Power switch is not opened Contrast and brightness/volume setup Press standby key on the remote control for
Trouble Shooting Digital TV Problems and possible Solutions. Picture Breaks into Pixels A typical example of a reception problem includes the break up of pictures (pixilation) or the picture freezing, sometimes there are clicking or squeaking sounds or the sound drops out or there is NO reception at all. Your picture may break into pixels due to the digital video signal dropping.
Specification Television picture quality: Full HD Integrated digital. Screen Size: 66"cm Resolution 1920 x 1080 pixels 50Hz. Connectivity: 2 HDMI sockets. 1 SCART socket. PC input socket. Component video socket. Composite. 1 USB port. Sound quality: NICAM stereo sound system. 2 x 8 watts RMS power output. Digital features: Digitally interactive. Digital text. Digital video broadcasting (DVB) subtitles available. Auto setup. Auto scan for new channels. Now and next programme guide.
Specification 32" Full HD 1080P Digital LED LCD TV with DVD Player Television picture quality: Full HD Integrated digital. Screen Size: 81"cm Resolution 1920 x 1080 pixels 50Hz. Connectivity: 2 HDMI sockets. 1 SCART socket. PC input socket. Component video socket. Composite. 1 USB port. Sound quality: NICAM stereo sound system. 2 x 8 watts RMS power output. Digital features: Digitally interactive. Digital text. Digital video broadcasting (DVB) subtitles available. Auto setup.