Installation Guide

© 2018 Halco Lighting Technologies, LLC. All rights reserved. Halco is a registered trademark of Halco Lighting Technologies. All sizes and specications are subject to change.
Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com | Atlanta | Chicago | Cleveland | Houston | Los Angeles | Phoenix
MOUNTING INSTRUCTIONS
Recessed Ceiling Mounting
The xture is suitable only for INDOOR RECESSED CEILING application.
1. Turn OFF power supply, ensure all required equipment and tools are present.
2. Rotate and slide the Housing as required to t through the Tee-Grid Bar and place it as shown.
3. Make sure that the orientation on of the Access Plate is easily accessible to make electrical splices.
Knock out appropriate conduit knockouts on the Access Plate to route input conduit.
Use appropriate conduit connectors as required by code.
4. Connect wires as shown in wiring diagram.
Warranty Information:
This product is warranted for 5 years from the date of purchase.
If this product does not perform to the specications supplied on this package, send an email or write to the address below for
product return and replacement. This replacement is the sole remedy available.
Liability for incidental or consequential damage is expressly excluded.
Visit www.halcolighting.com for full warranty details and compatibility information.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or
other sharp objects.
5. Reinstate the main power supply after connected and installed.
Operating Characteristic
Voltage input: 120-277V 50/80 Hz
Operating temp: -20°C (-4°F) to 40°C (104°F)
**Consult with dimmer control manufacturer’s wiring instructions