Instructions / Assembly

ProLED® Linear Vaportight-HLVT Series

Installation Instructions

Fig. 9

0-10V DIMMABLE WIRING

Universal voltage driver permits operation at 120V thru 277V,

50 or 60 Hz. For 0-10V Dimming, follow the wiring directions

in Fig. 9.

1. Connect the black xture lead to the LINE supply lead.

2. Connect the white xture lead to the COMMON supply lead.

3. Connect the GROUND wire from xture to supply ground.

4. Connect the purple xture lead to the (V+) DIM lead.

5. Connect the gray xture lead to the (V-) DIM lead.

6. Cap the yellow xture lead, if present. Do NOT connect.

NOTE: Do not connect DIM V+ (purple)/ DIM V- (gray) to line

voltage or supply ground.

ACCESSORIES - ANGLE MOUNTING

(ordered separately) - Fig. 7 and 8

1. Use appropriate mounting hardware (not supplied) to

secure the Corner Bracket (2) to mounting surface as

shown in Fig. 7.Corner Bracket must face towards each

other. Recommended Corner Bracket distance center to

center is 14-13/25” (for 2 ft) and 34-19/20” (for 4 ft & 8ft).

2. Secure Snap On Bracket (2) (supplied standard with

Housing) to Corner Bracket (2) with Screws provided as

shown in Fig. 7.

Snap Housing on Snap On Brackets (2) as shown in Fig.

2, Page 1. Ensure that Housing is secure to Snap On

Brackets (2) onto the grooves on Lens as shown in Fig.

1, Page 1

Corner Bracket (2)

Snap On

Bracket(2)

Housing

Screw(4)

Fig. 7

Fig. 8

ANGLE MOUNTING

The Installation must be carried out by a qualified electrician.

Warranty Information:

This product is warranted for ve years from the date of purchase.

If this product does not perform to the specications supplied on this package, send an email or write to the address below for product return and

replacement. This replacement is the sole remedy available.

Liability for incidental or consequential damage is expressly excluded.

Visit www.halcolighting.com for full warranty details and compatibility information.