Installation Guide
Page 11
Installation (Continued)
Figure 9
Figure 8
Figure 7
Figure 10
Store excess wires in the wiring box.5.
OPTIONAL: If you purchased a single-piece chimney cover, attach it to the hood in this step.6.
Drop oil tunnel into recess support near rear of hood. Refer to Figure 9.7.
To install bafe lters and stainless spacer(s), refer to 8. Bafe Filters and Stainless Steel Spacers on Page 18 for bafe
lter and stainless spacer placement. Refer to Figure 10 for the following ve steps:
Angle bafe lter toward back of hood.
Push bafe lter up until almost level.
Slide forward into recess behind the front of hood.
Lower bafe lter.
Slide back until it ts into resting positions.
Repeat Step 8 to install all bafe lters and stainless spacers.9.
OPTIONAL: Install heating lamps (not included) last. 120-Volt, 250-Watt maximum per lamp.10.
Turn powe ON in control panel. Check all lights and fan operations.11.
Make sure to leave this Installation Guide for the homeowner.12.