Product Brochure

Specifi cations, compliances and dimensions subject to change without notice
6
INCH
EATON Halo Product Catalog 6" Recessed Downlighting
6-7
LED Shallow Housing
H2750RICAT
6" IC, Air-Tite, Remodel, LED Housing
The H2750RICAT is a LED remodel housing for use in shallow
ceilings. The housing is designed for insulated ceilings and can
be in direct contact with ceiling insulation*. Housing features
Air-Tite code compliant construction. The LED connector system
provides high effi cacy code compliance when used with
compliant Halo LED lighting systems.
H2750RICAT
Features
1/2"
[13mm]
5"
[127mm]
6-1/4"
[159mm]
Ceiling opening to match
template supplied
14-1/2"
[367mm]
7"
[178mm]
Special Features
Quick Connect
™
push wire nuts
Air-Tite
™
code compliant
Compatible LED Modules & Trims
ML56 with designated shallow 69x series trims
SLD6
RL56
RA56
LT56
Housing
•
Single wall aluminum housing
•
Openings are gasketed for Air-Tite
™
•
Designed for insulated ceilings in direct contact with
insulation* (May also be installed in non-insulated ceilings)
•
For installation from below the finished ceiling. Integral
flange secures fixture against ceiling.
•
Halo identity embossed on can top
Remodel Springs
Four remodel clips secure housing and accommodate
1/2" and 5/8" ceiling material
Includes:
•
Quick Connect
™
push wire nuts (Details Pg. 9)
•
Air-Tite
™
code compliant (Details Pg. 9)
Junction Box
•
Seven 1/2" trade size conduit knockouts with true pry-out
slots are positioned to accommodate straight conduit runs
•
Four non-metallic (NM) cable pry-outs included
LED Module Connection
•
Halo LED modules install with a plug-in 120V/277V
rated line voltage wiring connector (UL and CSA
Listed luminaire disconnect)
•
This non-screw base connection preserves the high
efficacy rating and prevents use of low efficacy
sources (See LED module specifications)
Application Note
LED connection is rated for 120V and 277V input.
Installer must verify LED module voltage is compatible
with the applicable voltage input. If uncertain, consult
a qualified electrician.
Compliance
•
cULus Listed 1598 luminaire
•
cULus Listed damp location
•
cULus Listed for wet location,
covered ceiling, with select trims
•
cULus Listed for feed through
•
cULus Listed for direct contact with
insulation and combustible material*
•
Air-Tite code compliant. Certified under ASTM E283;
not exceeding 2.0 cfm (0.944 L/s) air leakage rate
tested at a 1.57 psf (75 Pa) pressure differential.
•
Rated for 20W maximum
•
Use with designated Halo LED systems for
ENERGY STAR
®
certification
•
Can be used for State of California Title 24 high efficacy
compliance with Title 20 Certified Halo LED
•
Can be used for International Energy Conservation Code
(IECC) high efficacy compliance with designated LED
modules and trims
•
Refer to LED module specification sheets online
for additional compliance information
•
RoHS compliant
*Not to be used in direct contact with spray foam insulation
(Consult NEMA LSD57-2013)