Operation Manual

21
GB
Causes of errors and error rectification
The following table can be used to localise and rectify minor errors with the device:
Error Possible cause Solution
General information
Display is blank
Device is switched off Switch on the device.
Power supply adapter not
connected correctly
Ensure that the power supply
adapter is plugged in and
connected to the device.
No mains power Check your fuse box.
Device is faulty
Inform our customer service
department.
Device turns off
By static electricity, such as
occur during normal daily
use (carpet, wool sweater),
it may happen that the
device will go into Standby
Mode.
In case that the device shouldn´t
react on any commands or show
a black screen, reset the device by
pressing the POWER button on the
remote control or on the backpanel
of the device.
DPF
No image
appears
No storage medium is
inserted
Insert a storage medium.
The storage medium does
not contain data
Check your storage medium.
Weather station
The outdoor sensor
displays no data
The inserted batteries have
little or no charge
Test or change the batteries
in the outdoor temperature
sensor and reconnect the two
units
Data from the
outdoor sensor is
displayed only occa-
sionally
Your outdoor temperature
sensor is too far away from
the weather station
Position your outdoor sensor
closer to the weather station
and reconnect the two units.
No weather data is
displayed
The temperature sensor
and the digital picture
frame are not in contact
with one another
Make sure that the plug
contact of the indoor sensor is
connected rmly and correctly
with the digital picture frame.
If necessary, disconnect the
device from the mains, recon-
nect the indoor sensor to the
picture frame, and switch the
device on again.