User manual
• Charge the speaker fully before using it for
the rst time.
• Connect the included Micro-USB charging
cable to the speaker’s Micro-USB port (3).
• Connect the unused connector on the
Micro-USB charging cable to a suitable
USB charger. Please refer to the operating
instructions for the USB charger used.
• The status LED (8) lights up constantly in
red during the charging process.
If the battery is fully charged, the status LED
(8) will go out.
Note – Charging
• It takes approx. 6-7 hours to
completely charge the product.
• The speaker’s battery can be charged
whether the speaker is on or off.
• If the battery capacity is less than
10%, the speaker will emit two
acoustic signals. You will only receive
this information if the speaker is on.
• Depending on the terminal device
connected (
Bluetooth
®
), the
speaker’s battery level will appear on
the device.
• The actual battery life varies depending
on use of the device, the settings and the
ambient conditions (rechargeable batteries
have a limited service life).
4.3 Audio playback via the included
audio cable (3.5 mm jack)
• Ensure that the speaker is switched off.
• Connect your mobile terminal device (MP3
player, smartphone, etc.) and the AUX-IN
input (2) of the speaker using the included
3.5 mm audio cable.
• Set the volume on your terminal device to
a low level.
• Switch on the speakers as described in
4.1,
Switching the product on and off.
• Press the function button – (7) to reduce
the volume.
• Press the function button + (5) to increase
the volume.
Note
Please note that you cannot establish the
Bluetooth
®
connection described under 4.4
and 4.5 if an audio cable is connected.
4.4
Bluetooth
®
pairing
Note
• Check whether your mobile device
(MP3 player, mobile phone, etc.) is
Bluetooth
®
capable.
• If not, you can only use the speaker
for playback using the included
audio cable.
• Note that the maximum range for
Bluetooth
®
is 10 metres without
obstacles such as walls, people, etc.
• Make sure that your
Bluetooth
®
capable
terminal device is on and
Bluetooth
®
is
activated.
• Make sure that the speaker is located within
the
Bluetooth
®
range of max. 10 metres.
• Switch on the speakers as described in
4.1
Switching the product on and off.
• Press and hold the ►
||
(
function button
(6) for approximately 3 seconds until an
acoustic signal sounds and the status LED
(8) ashes continually.
• Open the
Bluetooth
®
settings on your
terminal device and wait until PowerBrick
appears in the list of
Bluetooth
®
devices
found.
• Select PowerBrick and wait until the
speaker is listed as connected in the
Bluetooth
®
settings on your terminal device.
An short acoustic signal conrms that
connection was successful.
• The status LED (8) now remains blue.
Note –
Bluetooth
®
password
Some terminal devices require a
password in order to connect to another
Bluetooth
®
device.
• If your terminal device requests
a password for connection to the
speaker, enter 0000.