User manual
Note – Connection to a new
device
• If you want to connect a new
Bluetooth
®
terminal device to the
speaker, press and hold the ►
||
(
function button (6) for approximately
3 seconds until the status LED (8)
begins to ash blue and an acoustic
signal sounds.
• The current connection is
disconnected and the search for new
terminal devices starts.
• The speaker always stores the last
eight terminal devices paired.
• The speaker will automatically
connect to the last terminal device
paired when it is switched on the
next time.
4.5 Automatic
Bluetooth
®
connection
(after successful pairing)
• Make sure that your
Bluetooth
®
-capable
terminal device is on and
Bluetooth
®
is
activated.
• Make sure that the speaker is located within
the
Bluetooth
®
range of max. 10 metres.
• Switch on the speaker as described in 4.1
Switching the product on and off.
• After successful connection, the status LED
(8) will light up in blue. An acoustic signal
conrms that connection was successful.
Note – Connection impaired
After the speaker and terminal device
have been paired, a connection
is established automatically. If
the
Bluetooth
®
connection is not
established automatically, check the
following:
• Check the
Bluetooth
®
settings
of your terminal device to see
whether Po
werBrick is connected.
If not, repeat the steps listed under
Bluetooth
®
pairing.
• Check whether your terminal device
and the speaker are less than 10
metres apart. If not, move them
closer together.
• Check whether obstacles are
impairing the range. If so, move the
devices closer together.
• Check whether the audio cable is
connected to the speaker. If so,
disconnect it.
4.6 Audio playback (via
Bluetooth
®
)
Start and control audio playback on the
connected terminal device accordingly.
Alternatively, audio playback can also be
controlled on the speaker (if the connected
device supports this function).
• Press the ►
||
(
function button (6) to start
or pause audio playback.
• Briey press the function button + (5) to
increase the volume.
• Briey press the function button – (7) to
reduce the volume.
• Press and hold the + function button (5) to
jump forward one title.
• Press and hold the – function button (7) to
jump backward one title.
4.7 Hands-free function
You can use the speaker as a hands-free set
for your mobile phone. For this function,
the mobile phone must be connected to the
speaker via
Bluetooth
®
.
• Press the function button ►
||
(
(6) once to
answer an incoming call.
• Press and hold the function button ►
||
(
(6) for approx. 2 seconds to reject an
incoming call.
• You can put a call on hold by pressing and
holding the ►
||
(
function button (6) for
approximately 2 seconds.
• Press and hold the ►
||
(
function button (6)
again to continue the call.
• During a call, press the function button
►
||
(
(6) once to end the call.
Note – Call quality
To increase the call quality, make sure
that you are near the speaker with your
mobile phone during the call.