Instructions / Assembly

Insert the blade screw (AA) through the blade (F) and the

blade holder (E). Start the blade screw (AA) through the flat

washer (CC) into the hexagon nut (BB). Repeat this

procedure without tightening the screws until all three

screws (AA) have been started into the hexagon nuts (BB).

Once all three screws (AA) are attached, tighten each

screw (AA) securely starting with the center screw. Make

sure the blade (F) is straight.

Repeat these steps for the remaining blades (F) and

blade holders (E).

Fasten blade assemblies (F) to the motor (D) with the motor

screws (HH) and lock washers provided.

Repeat the procedure for the remaining blade assemblies

(F). Make sure all motor screws (HH) are tightened securely.

Slide the canopy (B) up to the hanger bracket (A)

matching the L-slots on the canopy (B) to the two screws

(MM) on the hanger bracket (A). Turn canopy (B) until it

locks in place.

Insert the two previously removed screws (MM) through

the canopy (B) and into the hanger bracket (A).

Tighten all four screws (MM).