Installation Guide

11
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Attaching the Fan Blades
F
I
ZZ
Assembly - Hanging the Fan (continued)
Mounting the fan-motor assembly
(close-to-ceiling mount)
□ Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place. Immediately tighten
the two mounting screws rmly.
□ Install the two mounting screws (FF) and lock washers (GG)
(saved from Assembly Step 1 “Prepairing for mounting” into
the holes in the canopy (C) and tighten rmly.
□ You may now proceed to attaching the fan blades.
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and rmly tightened.
6
F
D
C
A
FF
GG
Attaching the blade brackets
1
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for quick
and easy blade installation, including an alignment post and
captive blade bracket screws.
IMPORTANT: The switch cup has an access hole (ZZ) to allow
the screwdriver to reach the screws in the blade bracket.
Position the blade bracket on the motor and tighten by
inserting the screwdriver through the access hole (ZZ).
□ Fasten the blade brackets (I) to the fan-motor assembly (F) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the pre-installed blade bracket screws
by inserting a screw driver through the access hole (ZZ).
□ Repeat this step for the remaining blade assemblies by
rotating the motor until the next blade bracket screw can be
accessed through the access hole (ZZ) in the switch cup.